RhinoPower Ltd

It looks much the same as my Baleno, can you take a picture of the inside of the ECU? that would be useful.
Cheers
James

penjoseph wrote:

---

I couldn't note down the rest of the numerical series on the ECU. Maybe next time when I visit the garage.

Are you still working on the LCD display panel similair to the Scangauge?

Is there any way re-map the Timing/Fueling curve of the stock ECU using an external soft flasher connected to the OBD port? On disconnection of the unit the ECU retains stock values.

refer: Volo Performance Chip

---

I still need to find a couple more addresses for the stock ECU before I can finish the display unit.  Also I may be picking up a Baleno this weekend, it has the factory trip computer so that will be interesting. I will post up some info on that when I get a chance to look into how it works

I haven't been able to erase the memory on the 65G60, I'm hoping to ba able to borrow a proffesional programmer in a few weeks time if that happens I'll have another attempt at it. It may be a semi-custom processor so it would need to be swapped for a different one.

The Volo chip doesn't work because it can't. The manufacturers have made contradictory statements about how it is supposed to work but its all nonsense anyway. It supposedly uses the OBD2 port so even if their claims were true it wouldn't work on early Zuks anyway.

I tried clearing my chache & tried for a couple of days. Using Mozilla Firefox. There seems to be a problem directory lisitng in your html pages.

When I click on the 'Hardware' tab in the home page
http://www.rhinopower.org/index.html
it goes to a 'page cannot be found' with this address
http://www.rhinopower.org/diag_index.html

I think that page should link to:  http://www.rhinopower.org/diag/diag_main.html


There is another problem. After going to the home page if I click on 'Software' tab & then the 'Hardware' tab, it is re-directed to another 'page cannot be found' with another address:
http://www.rhinopower.org/ECU_index.html

Tried Internet Explorer but still the same

So you have the 'Hardware' tab pointing to 2 different web pages.




-- Edited by penjoseph on Wednesday 20th of October 2010 08:57:23 AM

There may be a problem with your browser caching old pages, try hitting F5 a few times.

The Rhinopower interface will work with your ECU, I have personally tested it on several different Baleno ECUs and SpaDival had a similar interface working on an Indian Baleno. What are the numbers after 33920? Your engine has the same ignition setup as my Baleno engine, the main difference is that my engine is on the garage floor and not in a vehicle!
I have most of the mapping for two Baleno models, in a couple more weeks I should have the other locations know.

OBD port
Pin 5 -ve
Pin 9 digital signal
Pin 16 +ve

umm - the the link to the top level schematic shows a picture of the ECU board - I know that can be considered "top level", but I have a feeling that it's not what you wanted.